Â鶹´«Ã½

Skip navigation

Gulf Coast Research Laboratory

Procedures for Sampling

Page Content

Grab Samples Water Analysis

procedure for sampling - oystersCollect water samples approximately one-half meter below the surface or middle of the water column in a closed system. Invert a sterile bottle, remove the cap, collect the sample, and replace the cap.  If collecting samples from a boat – collect on the windward side, out of the prop wash or any disturbance.  An air space of approximately one to one- and one-half inch from the top of the bottle must be left in the bottle (for proper shaking). Samples delivered with insufficient shaking space will not be analyzed.  Ice the bottle for transport.  Samples must be upright in ice, tightly sealed, and not subject to contamination from melting ice.  Bottles submerged in ice (above the neck) will not be analyzed. An extra sample bottle should be collected at the last station for use as a temperature check.   

Meat Sample Analysis

Shellfish samples from oyster reefs should be collected using tongs or the dredge. Single set oysters can be removed from off-bottom oyster cages.  About 15-20 medium size oysters are necessary to constitute a sample.  Oysters should be rinsed thoroughly and placed in a double-lined plastic bag. Seal the bag and place on ice, not in ice. 

Contact Us

Gulf Coast Research Laboratory

Physical Addresses

GCRL - Halstead
703 East Beach Drive
Ocean Springs, MS 39564

GCRL - Cedar Point
300 Laurel Oak Drive
Ocean Springs, MS 39564

Mailing Address

703 East Beach Drive
Ocean Springs, MS 39564

Campus Map

Email
gcrlFREEMississippi

Phone
228.872.4200

Fax
228.872.4292